September 17, 2008tough yes, but if it keep sbreaking everything conected to it. i am still walking.
|1 |||2 |||3 |||4|
September 18, 2008Motor is in.
October 8, 2008okay need input from the tech heads here. I set the timing at 10deg BTDC per the factory setup. I need to know if that is on the money *or* does it need to be set at something else.
October 8, 2008How does it run at that point.
October 9, 2008it has a small hesitation, but after that it start building RPM qickly.
October 13, 2008injectors are to big. will be taking the 24lbs out and putting the 19lbs back in.
October 15, 2008well it sounded really good when I heard it..
I noticed your city changed.. did you move already?
oh and Patrick and a few others saw your work today at Infinity Conversions...
JJ wasnt there.,.
October 15, 2008will be moving this weekend. I was updating all of my profiles yesterday, due to getting laidoff. They gaveme until the end of the month.
May 6, 2011okay guys, here is a update on the new motor.
truck ran strong even with the timing issue, but just last month i had to break it down to check for piston blow by. I found 2 valves leaking and a blown head gasket. So once again the motor is torn down. The up side is i get to do the porting on the intake and heads now. I know about porting. luckly for me a buddy of mine is very knowledgable about it and is teaching me how to do it. (Note to any one who wants to try this on a whim. Don`t! Had it not ben for my buddy i would be buying a new set of heads, due to not knowing what i was doing. It can go bad in less than 30 sec`s!!!) I am going to post some of the photo`s.
May 6, 2011okay here are some pictures of my first attempt at porting heads. (keep in mind i have a coach helping me.)
Here is a partialy unmodified port.
Here is one port at 85% complete and the other at about 40% complete.
May 7, 2011Good work! I usually run 14* base timing (spout connector unplugged) on all my fuel injected ford small blocks, makes a noticeable difference from the stock settings. Sucks that ya hafta tear it down again tho...
|1 |||2 |||3 |||4|